miamitj Posted April 22, 2004 Report Share Posted April 22, 2004 Hi all, First is First .. Im a total Linux noob -- this is my second system I have set mandrake 10 on and I really dont know much ... Well I installed 10 on my laptop and all was fine -- no problems at all ... I set up my wireless card and was surfing in minutes .. I rebooted and it was gone -- it shows the setup (eth1) but I dont see the wireless card under the harddrake ... Well I figured I screwed something up so I just reinstalled and all was fine --- Till I rebooted -- Same again ps .. I did not start/install any apps either time ... Can I have a pcmcia driver issue -- Where do I start looking and what commands would I use ... Please remember Im a noob ... Quote Link to comment Share on other sites More sharing options...
liquidzoo Posted April 22, 2004 Report Share Posted April 22, 2004 What kind of card do you have? Is it set (in MCC -> Network) to start at boot? What driver are you using? What steps did you go through to set it up? I can most likely help, but I need some more info from you so we can start looking at the various options. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.