Guest Costra Posted October 30, 2004 Report Share Posted October 30, 2004 Hi, I bougth Acer TravelMate 4001WLMi and install MDK 10.1 CE (Now I updated on the Official). Now I have a few (more than less) troubles. 1, ACPI doesn't work. When I change apci=off or acpi=ht on something else, when it booting it freeze with messages "IRQ9 SCI: Edge set to Level Trigger" (acpi=on) or "calibrating delay loop" (nolapic noacpi). 2. Wireless (Wifi) doesn't work too. I download firmware from ipw2200.sf.net and configure it. But when I try: > sudo ifup eth1 Error for wireless request "Set Mode" (8B06) : SET failed on device eth1 ; Operation not supported. Determining IP information for eth1... failed. > cat /etc/sysconfig/network-scripts/ifcfg-eth1 DEVICE=eth1 BOOTPROTO=dhcp ONBOOT=yes HWADDR=00:00:00:00:00:00 METRIC=10 MII_NOT_SUPPORTED=no WIRELESS_MODE=Auto WIRELESS_ESSID=VELKY_BRATR DHCP_HOSTNAME=costrantb2 NEEDHOSTNAME=no > lsmod |grep ip ipv6 230916 16 ipw2200 51252 0 firmware_class 7232 1 ipw2200 ieee80211 13444 1 ipw2200 3. Special keys doesn't work with acerhk module. I installed it by INSTALL manual and modprobe (I can see it in lsmod), but xev doesn't show keycodes instead off keys for mail and internet (these two keys are functional without acerhk too). 4. USB2 goes sloooowly like USB1, but on my desktop with the same MDK version, it goes great. When I connect my usb hdd, I get next in messages: Oct 24 10:46:56 COSTRANTB kernel: usb 2-1: new full speed USB device using address 4 Oct 24 10:46:56 COSTRANTB kernel: usb 2-1: not running at top speed; connect to a high speed hub Oct 24 10:46:57 COSTRANTB kernel: scsi2 : SCSI emulation for USB Mass Storage devices Oct 24 10:46:57 COSTRANTB kernel: Vendor: ST380021 Model: A Rev: 0 0 Oct 24 10:46:57 COSTRANTB kernel: Type: Direct-Access ANSI SCSI revision: 02 Oct 24 10:46:57 COSTRANTB kernel: SCSI device sdb: 156301488 512-byte hdwr sectors (80026 MB) Oct 24 10:46:57 COSTRANTB kernel: sdb: assuming drive cache: write through Oct 24 10:46:57 COSTRANTB kernel: /dev/scsi/host2/bus0/target0/lun0: p1 Oct 24 10:46:57 COSTRANTB kernel: Attached scsi disk sdb at scsi2, channel 0, id 0, lun 0 Oct 24 10:46:58 COSTRANTB scsi.agent[32083]: disk at /devices/pci0000:00/0000:00:1d.1/usb2/2-1/2-1:1.0/host2/2:0:0:0 5. Network freeze on 4 minutes on booting, than booting continues. When I set ONBOOT=yes in eth0 and eth1 it freeze two times on 4 minutes, when I set ONBOOT=off on eth1 it freeze one times 4 minutes, and when I set eth0 ONBOOT=off too it freeze 4 minutes on localhost... I will happy for some responses... I still hope I will not throw the notebook from window. :-( Thanks. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.