Guest jonesieboy Posted May 15, 2005 Report Share Posted May 15, 2005 (edited) I'm running 10.1 on a Fujitsu Lifebook. Since installing the Thac rpms for KDE 3.4 my Internet connection through a wireless card has started to drop intermittently. The wireless connection stays up, but the Internet connection goes down. Clicking on "connect to ethernet" in the network monitor brings it straight back up again. #ifconfig lo Link encap:Local Loopback inet addr:127.0.0.1 Mask:255.0.0.0 inet6 addr: ::1/128 Scope:Host UP LOOPBACK RUNNING MTU:16436 Metric:1 RX packets:56850 errors:0 dropped:0 overruns:0 frame:0 TX packets:56850 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:0 RX bytes:9352748 (8.9 Mb) TX bytes:9352748 (8.9 Mb) wlan0 Link encap:Ethernet HWaddr 00:0F:B5:48:B2:54 inet addr:10.0.0.13 Bcast:255.255.255.255 Mask:255.0.0.0 inet6 addr: fe80::20f:b5ff:fe48:b254/64 Scope:Link UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 RX packets:5797 errors:0 dropped:0 overruns:0 frame:0 TX packets:165862 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:1000 RX bytes:5824014 (5.5 Mb) TX bytes:7312907 (6.9 Mb) Memory:10810000-1081ffff #route Kernel IP routing table Destination Gateway Genmask Flags Metric Ref Use Iface 10.0.0.0 * 255.0.0.0 U 0 0 0 wlan0 127.0.0.0 * 255.0.0.0 U 0 0 0 lo default 10.0.0.2 0.0.0.0 UG 0 0 0 wlan0 #cat ifconfig-wlan0 DEVICE=wlan0 BOOTPROTO=dhcp ONBOOT=yes METRIC=10 MII_NOT_SUPPORTED=yes WIRELESS_MODE=Managed WIRELESS_ESSID=(myhomenetwork) WIRELESS_ENC_KEY=(mykey!) #cat resolv.conf nameserver 10.0.0.2 Can anyone help? Robert Edited May 19, 2005 by jonesieboy Quote Link to comment Share on other sites More sharing options...
Guest jonesieboy Posted May 19, 2005 Report Share Posted May 19, 2005 Fixed itself when I ripped out all the thac rpms for KDE and reinstalled from 10.1 official. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.