Jump to content

USB device fails to load kernel module.

Recommended Posts

When I connect my OnAir USB TV receiver I get the following 6 lines in dmesg.


usb 2-3.3: new high speed USB device using ehci_hcd and address 3
usb 2-3.3: New USB device found, idVendor=11ba, idProduct=1101
usb 2-3.3: New USB device strings: Mfr=1, Product=2, SerialNumber=0
usb 2-3.3: Product: USB HDTV-GT(1.1)
usb 2-3.3: Manufacturer: OnAirSolution
usb 2-3.3: configuration #1 chosen from 1 choice


A kernel module is supposed to load after those 6 lines from the USB stack, problem is it's not loading. The module that's supposed to load is



Where should I begin to debug this problem?


By the way, are Mandriva's kernel modules normally in .gz form when on disk?

Edited by boatman9
Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


  • Create New...